The types of engraving methods on metals are as follows.
-Percussion engraving (percussion or needle engraving)
-Scribe engraving (scratching)
-Roll marking engraving
-Laser engraving
-Gate engraving and chip removal
-further engraving (Percy)
-Electrochemical etching
Percussion engraving robot (percussion, needle)
The pen mechanism of devices in the percussion engraving method is in two ways.
-Pneumatic engraving robot
-Magnetic engraving robot
Impact engraving or percussion in a pneumatic pretentiousness
In the pneumatic method, the driving force of the pen is provided by wind, which is available in exchange models for engraving exchange parts
Magnetic needle engraving or hammering
In the magnetic method, the gift of the device is supplied by the coils of the pen and is controlled by electronic circuits, on depth of in the pneumatic method. The number of points in the magnet pen can be controlled and adjusted. The magnetic system has less depth and far away away less noise pollution than the pneumatic system.
Laser engraving
In the laser method, the ray is produced by stimulating the laser generating material by electric exoneration or the radiation of a lamp in a chamber, and the beam is reflected using a mirror to get your hands on the vital simulation to become a lighthearted stream. The mirror is usually used to gain the light to the lens, and through the lens, the fresh shines upon the slant, and engraving is the withdraw.
Scribe or graze engraving
It is one of the newest engraving methods in the world. In this method, the needle of the robot, which is usually made of tungsten carbide, penetrates the surface of the desired piece or sheet and along with performs the engraving operation. A no consider avant-garde pretentiousness to engrave taking into consideration the complete high atmosphere and without any noise pollution (shy) is the best approachable unconventional in cases where there are restrictions associated to noise pollution. دستگاه حکاکی
Comments
Post a Comment